Tikkurila Industry 9L
ОПИС A two component solvent free epoxy putty.
КАРАКТЕРИСТИКИ НА ПРОИЗВООДОТ Suitable for patching of holes, cracks and seams.
Перпорачана употреба Concrete, gypsum and other mineral surfaces. May also be used on wood, plywood and steel surfaces. Porous mineral surfaces have to be primed with epoxy varnish or paint before patching.

Features Does not contain Volatile Organic Compounds.
Палета на бои Wood.

9 - 11 m2/l (100 μm).

Practical coverage depends on the extent of holes, cracks and seams and on the unevenness of the substrate.

Indication: about 1 litre putty/1 mm/m2.

Mixing ratio Putty 2 parts by volume 008 4611
Hardener 1 part by volume 008 4612
Метод на примена Rubber or steel spatula.
Pot-life (+23°C) abt. 1 h after mixing.
Drying times


+ 23 ºC

Recoatable, after

8 h - 4 d

Ready for sanding, after

12 - 24 h

Dry through, after

7 d

Lower temperatures prolong the drying time.
Содржина на цврсти материи abt. 100 % by volume.
Густина 1.10 kg / litre (mixture)
Шифра на производот 008 4611

Услови за примена All surfaces must be dry. The relative humidity of the concrete should not exceed 97 %. The temperature of the ambient air, surface or coating should not fall below + 15 ºC during application or drying. Relative humidity of air should not exceed 80 %.
Припрема Remove dust, loose particles and other impurities from the surface.
Priming Prime porous surfaces with TEMAFLOOR 200 or 210 epoxy varnish. In epoxy systems also the standard primer of the system can be used.
Diluting Do not thin.
Application Apply COLOFILL with a rubber or steel spatula. The patching is carried out to the final level of the surface avoiding surpluses. If the surface is very uneven it is recommended to apply the putty in two layers with an interval of about 8 hours. Grind the patched areas after 12 hours (+ 23 ºC) Use dry or wet grinding or scraping.
Mixing of components Add hardener to the base and mix thoroughly. The amount of mixture depends on the area to be coated and on the pot life of the mixture. Insufficient mixing or incorrect mixing ratio will result in uneven drying of the surface, weaken the properties of the surface and risk the success of the work.
Чистење на алатот Thinner 1029 or 1031.
EU VOC 2004/42/EC ограничена вредност Does not contain Volatile Organic Compounds.

во согласност со Регулативата (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only.
Safety data sheetCOLOFILL putty [GB-ENG]
Hardener safety data sheetCOLOFILL hardener [GB-ENG]