ТЕХНИЧКИ ЛИСТ
18.06.2013

Ensi

 
Tikkurila Industry 9L
ОПИС Urethane oil.
КАРАКТЕРИСТИКИ НА ПРОИЗВООДОТ For oiling of concrete surfaces. Penetrates into concrete without forming a protective film.
Перпорачана употреба Suitable for concrete floors and walls in industry, store and cellar spaces.

ТЕХНИЧКИ ПОДАТОЦИ
Features Withstands well abrasion and washing. Resistant against petrol, spirits and lubrication oils and grease. Resistant against vegetable and animal grease and weak solutions of acids and alkali.
Палета на бои Clear.
Gloss groups Gloss
Покривност

Coverage on concrete floors is on the average:

Porous concrete surfaces:     3 - 6 m2/l

Tight concrete surfaces:    10 - 15 m2/l

 

Practical coverage depends on the porosity of the substrate and on the application method.
Разредувач 1050
Метод на примена By brush or roller.
Време на сушење на 23°C и 50% релативна влажност на воздухот

Dust dry after      2 hours

Touch dry after    6 hours

 

Dries also in low temperature, over +5ºC.
Содржина на цврсти материи 30±2% volume.
Густина 0.8 kg / l
Шифра на производот 005 0433

ДЕТАЉИ ЗА ПРИМЕНА
Услови за примена The relative humidity of the concrete should not exceed 97 %. The temperature of the ambient air, surface or coating should not fall below +5ºC during application or drying. Relative humidity of air should not exceed 80%.
Припрема New concrete: Remove laitance by power grinding or hydrochloric acid etching. Choose the method best suited for the premises. After cleaning remove dust carefully with a vacuum cleaner. Hydrochloric acid etching is carried out with diluted hydrochloric acid (1 part concentrated hydrochloric acid, 4 parts water). Rinse with plenty of water. Dry the floor.

Old concrete: Remove all grease, oil, chemicals and other impurities by MAALIPESU detergent. Clean out pot-holes removing all loose friable material. Open cracks with e.g. an abrasive tool. Remove loose material and dust.
Priming Prime using 10-20% thinned ENSI urethane oil. Pour ENSI onto the floor and apply evenly.
Treatment Application by brush or roller.

The second treatment can be carried out after 12-24 hours after priming if necessary. Note! Apply ENSI thinly so that after drying it has completely absorbed into the concrete.
Чистење на алатот White spirit 1050.
EU VOC 2004/42/EC ограничена вредност VOC 2004/42/EC (cat A/h) 750 g/l (2010)
Ensi: max. VOC < 750 g/l

КЛАСИФИКАЦИЈА ЗА БЕЗБЕДНОСТ И ЗДРАВЈЕ
во согласност со Регулативата (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj.
Safety data sheetENSI URETHANE OIL [GB-ENG]
 
-


Назад