ТЕХНИЧКИ ЛИСТ
09.10.2013

Fontecryl PP

 
Tikkurila Industry 9L
ОПИС A waterborne, one component fast drying acrylic based primer containing active anticorrosive pigments.
КАРАКТЕРИСТИКИ НА ПРОИЗВООДОТ Suitable for spraying and dipping. Drying times can be shortened by using higher temperatures. Overcoatable with a wide range of products, also with solventborne products. Recommended e.g. as an anti-corrosive primer under powder coatings on steel.
Перпорачана употреба Steel surfaces.

ТЕХНИЧКИ ПОДАТОЦИ
Палета на бои Grey.
Gloss groups Matt
Покривност

Recommended film thicknesses

Theoretical coverage

dry

wet

 

15 µm

45 µm

22.7 m2/l

30 µm

90 µm

11.3 m2/l


Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Разредувач Water
Метод на примена By airless or conventional spray or dipping.
Drying times

DFT 30 µm

+ 23 ºC

Dust dry, after

20 min

Touch dry, after

30 min

Through dry, after

24 h

Recoatable with powder coatings, after

Note! Before overcoating all the solvents and water have to be evaporated from the primer.

20 - 30 min

Through dry at increased temperatures after 15 min / 60 ºC


Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Содржина на цврсти материи 34 ±2%
Густина 1.15–1.2 kg/l
Шифра на производот 006 5980

ДЕТАЉИ ЗА ПРИМЕНА
Услови за примена All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +15 ºC during application or drying. Relative humidity should be between 20 - 70 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
Припрема Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)

Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1) If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.
Priming Fontecryl PP.
Finishing Powder coatings.
Премачкување By airless or conventional spray or dipping. Depending on the application method the paint can be thinned 0–10%. At dipping the viscosity should be 15–20s DIN 4 and at conventional spray application 20–30s DIN 4.
Before overcoating all the solvents and water have to be evaporated from the primer.

Note! The viscosity falls quickly when thinning the paint.
Чистење на алатот Water and Thinner 1031.
EU VOC 2004/42/EC ограничена вредност The Volatile Organic Compounds amount is 40 g/litre of paint.
VOC content of paint (thinned 10 % by volume) is 35 g/l.

КЛАСИФИКАЦИЈА ЗА БЕЗБЕДНОСТ И ЗДРАВЈЕ
во согласност со Регулативата (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For industrial and professional use only.
Safety data sheetFONTECRYL PP GREY [GB-ENG]
 
-


Назад